Gauge cluster removal & SRS bulb replacement / removal

Above: Next, flip over the gauge cluster and you need to remove the back white plastic. To do that, remove the two screws and unscrew the light bulb indicated by the arrow if yours has wires like mine. The backing clips in as well on the sides so unclip everything and it should pop off. 
Below: Next you need to remove the computer circuit board. To do that you need to remove each bulb from the back. Be careful to note which bulb goes where before removing them. Also, you need to remove all 4 gauges and all their screws. Be very careful on this process and hold the gauge from the front making sure not to touch the needles. Keep the gauge screws seperate so you know which ones go where. I cna’t stress this enough -make sure that you note how the guages came out (top and bottom) as they will need to go in exactly the same to work correctly!!! There are also two or more screws holding the circuit board which must be removed.

Click here to go to the next page